by fgtechadmin | Nov 19, 2024 | Uncategorized
We are excited to announce the latest update that introduces new programming protocols for CONTINENTAL/VITESCO SID321 engine control units, requested by many tuners to solve the known problems on this type of engines.The Benchmode protocol is available that allows you...
by fgtechadmin | Nov 14, 2024 | Uncategorized
FGtechnology EOBD2 now supports reading in Bootmode for EMS2301 – EMS2302. These ECUs are equipped on 1.2 Ti-VCT petrol engines of the Ford brand. From now on it will be possible to improve the performance of this model and also it will be possible to clone the...
by fgtechadmin | Nov 6, 2024 | Uncategorized
FGtechnology EOBD2 now supports reading in Bench and Boot mode for MED17.8.10.1 and MED17.8.10. These ECUs are equipped on 1.0 and 1.5 T-GDI petrol engines of Ford, MG and Saic brands. Reading and/or writing can be done directly via PINOUT without having to open the...
by fgtechadmin | Oct 31, 2024 | Uncategorized
FGtech EOBD2 now supports reading and writing of all versions of Continental SID807 via OBD. Previously only writing in diagnosis was supported now full reading of flash and eeprom and writing for both versions has been implemented. ♦ Reading (Flash+Eeprom)♦ Writing...
by fgtechadmin | Oct 29, 2024 | Uncategorized
FGtech EOBD2 now supports Benchmode reading for Bosch EGC4.0 – EDC17CB25. These control units are equipped on CNG methane engines of the G410, P410 and R410 Series. With this update we have implemented the support of control units for the Scania brand, providing...
Recent Comments